If you have a synchromesh gearbox and you want our synchro kit, that is extra 1040 EUR (in a kit) + VAT. Base price for a kit is 4000 eur + VAT. We require 1000 eur advance and the rest before shipping. We also offer USD, UK and AUD based bank accounts. We prefer wire transfer, however, paypal is also possible, but we have to charge extra 5.5% for the paypal fee (paypal takes this, not us). Most of the components can be easily replaced. This is the most important step and must be measured very accurately.

You need to measure travel of each cable for each gear. What do you need from me before you can start?.360 x 120 x 140 mm with all accessories included (safety switch, relay, pressure regulator) With synchronized gearbox (by GCU automatically pressing the clutch), you're looking at around 200 - 450 ms.Īir bottle (tank): 290 x 120 x 140 mm. Realistically around 80 - 120 ms is possible on a dogbox. It takes around 20-40 work hours to install this system in a car. With software installed and car running we recommend a fine tuning on a dyno to test everything in safe and controlled environment. If it does not, then you need to wire the ignition coil supply into the gear control unit (only if you want full throttle shifting) If your ECU support engine unload (ignition cut, retard, fuel cut) you need to connect signal wire from gear control unit to your ecu. If your gearbox is synchromesh and you purchased synchro kit, then you need to mount clutch actuator and connect it between the existing clutch line. If your car has a CAN BUS or you need to communicate with a CAN BUS device (like dashboard), you need extra 2 wires, CAN+ and CAN. Basically you need 12V from ignition switch, ground, paddle up/down switches, clutch switch and neutral switch. Gear control unit must be wired according to diagram. Air compressor and air reservoir must be mounted and connected to power and gear control unit Cables on the actuators side need M6 male thread.

Usually the cables need to be shortened to properly fit. Gear lever must be replaced by the h-paddle shifter assembly. What is needed to install this into my car?.What we do is we supply additional actuator and hydraulic actuator that presses and releases the clutch automatically. It is possible to use our system if you have hydraulic clutch.

Download full throttle motorsport